Oracle Acme Packet 1100 Hardware Installation And Maintenance Guide

• Vertical installation on either a wall or other surface
• Table top installation
Note:
Failure to follow the instructions outlined in this section might compromise the proper
functioning of the Acme Packet 1100.
Unpacking the Acme Packet 1100
To unpack the Acme Packet 1100:
1. Inspect the external packing materials and note if they are damaged in any way.
2. Open the exterior box.
3. Unpack the contents of the Acme Packet 1100 shipment.
4. Locate the packing list that comes with the Acme Packet 1100 shipment; the packing list is
located outside of the shipment box.
5. Confirm that all of the components listed in the shipping box contents are present and in
good condition.
If you discover that any of the parts are missing or were damaged in shipment, contact
Oracle to request assistance.
Mounting Hardware
The hardware used for the Acme Packet 1100 mounting procedures is presented in the
following subsections.
Equipment Rack Installation Hardware
The Acme Packet 1100 can be front- or center-mounted in a standard 19 in or 23 in wide rack.
Optional rack mount flanges are available to attach to each side of the front of the chassis and
then directly to the rack.
Figure 3-1 Rack Mount Flanges (Optional)
Chapter 3
Mounting Installation
3-4

Oracle Acme Packet 1100 Specifications

General

Brand	Oracle
Model	Acme Packet 1100
Category	Controller
Language	English