Note:
The following procedure is only applicable to Acme Packet 1100s in an HA
deployment.
To force a switchover between Acme Packet 1100 nodes:
1. Confirm that the relevant systems on the active/standby are synchronized with the show
health command. Type show health and press Enter on each system.
Figure 5-2 Issuing the Show Health Command - Active System
ORACLE# show health
Media Synchronized true
SIP Synchronized true
REC Synchronized disabled
MGCP Synchronized true
XSERV Synchronized disabled
Config Synchronized true
Collect Synchronized true
Radius CDR Synchronized disabled
Rotated CDRs Synchronized disabled
IPSEC Synchronized disabled
Iked Synchronized disabled
Service Health Synchronized true
Active Peer Address 0.0.0.0
Redundancy Protocol Process (v3):
State Active
Health 100
Lowest Local Address 169.254.1.1:9090
1 peer(s) on 2 socket(s):
SML-STIC-2: v3, Standby, health=100, max silence=1050
last received from 169.254.1.2 on wancom0:1
Switchover log:
Jun 25 19:03:02.029: Active to BecomingStandby
Jun 25 19:04:54.684: Standby to BecomingActive
ORACLE#
synchronized
applications
active system
Figure 5-3 Issuing the Show Health Command - Standby System
ORACLE# show health
Media Synchronized true
SIP Synchronized true
REC Synchronized disabled
MGCP Synchronized true
XSERV Synchronized disabled
Config Synchronized true
Collect Synchronized true
Radius CDR Synchronized disabled
Rotated CDRs Synchronized disabled
IPSEC Synchronized disabled
Iked Synchronized disabled
Service Health Synchronized true
Active Peer Address 169.254.2.1
Redundancy Protocol Process (v3):
State Standby
Health 100
Lowest Local Address 169.254.1.2:9090
1 peer(s) on 2 socket(s):
SML-STIC-2: v3, Active, health=100, max silence=1050
last received from 169.254.2.1 on wancom0:1
synchronized
applications
active system
Chapter 5
Forcing Switchover for HA Nodes
5-4
To Next Page
Loading...
Need help?
General
