How to Replace a Disk Shelf Power Supply
Using your thumb and forefinger, unscrew both ejection arm captive screws until loose and
swing the ejection arms out until they are fully open.
6.
Pull the module out of the chassis, being careful not to damage the connector
pins in the back.
7.
With the lever/ejection arms fully open, slide the new module into the chassis
slot until it contacts the chassis backplane, and the lever/ejection arms begin to
engage.
8.
Close the lever/ejection arms.
Oracle Storage Drive Enclosure DE2-24P or DE2-24C:
Servicing the Hardware 255
To Next Page
Loading...
