Orange Pi Zero 2 - SSH Remote Access

19
THE OFFICIAL ORANGE PI USER'S GUIDE
Changing the screen resolution.
The screen resolution can be changed by choosing a different mode for the
disp_mod variable and adjusting the width/height values of the frame buffer.
We need to change the values of fb0_width, fb0_height, and disp_mode in the /boot/
orangepiEnv.txt file according to the following table.
disp_mode fb0_width/fb0_height Frame rate
480i
720x480
60
576i
720x480 50
480p 720x480
60
576p 720x576
60
720p50 1280x720 50
720p60 1280x720
60
1080i50
1920x1080 50
1080i60
1920x1080
60
1080p24 1920x1080
24
1080p50 1920x1080 50
1080p60 1920x1080
60
Setup SSH remote access
SSH remote login development board under Ubuntu
1) Get the IP address of the development board
2) Then you can log in to the linux system remotely through the ssh command
Note: Need to be replaced with the IP address of the development board
$ ssh root@192.168.1.36
Next: Enter the password here, the default password is orangepi
root@192.168.1.36's password: