EasyManuals Logo

Orban OPTIMOD 6200 User Manual

Orban OPTIMOD 6200
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
3-20
OPERATION ORBAN Model 6200
The Two-Band Structure
The Two-Band structure consists of a slow two-band gated AGC (Automatic Gain Con-
trol) for gain riding, followed by a gated two-band compressor and a look-ahead limiter.
Like the “2-Band Purist” structure in Orban’s OPTIMOD-FM 8200, it is phase-linear
throughout to maximize sonic transparency.
This structure is equipped with a CBS Loudness Controller, intended primarily for tele-
vision applications.
The Two-Band structure has an open, easy-to-listen-to sound that is similar to the source
material if the source material is of good quality. However, if the spectral balance be-
tween the bass and high frequency energy of the program material is incorrect, the Two-
Band structure (when its
B2>B1 CPL
control is operated toward 0%) can gently correct it
without introducing obvious coloration.
The Two-Band structure is mainly useful for classical or “fine arts” programming that
demands high fidelity to the original program source. Its two-band compressor and look-
ahead limiter are identical to the Protection Limiter structure, although more controls are
made available to the user.
Setting Up the Two-Band Structure
To set up the Two-Band structure for radio, recall preset
2B CLASSICAL
for a “smooth,”
unprocessed-sounding quality, or
2B PROCESSED
for a louder, more processed sound.
Of course, you can modify any preset using the
LESS-MORE
control or using the Full
Control screen, and you can then store the resulting modified preset as a User Preset for
future recall at any time.
Note that choosing a conservative Multi-Band preset (like one of the
POP
presets or
INSTRUMENTAL
) will usually create an even more attractive, smooth, and consistent
sound on pop music than will the Two-Band structure. Additionally, because each band
in the Multi-Band structure handles a smaller part of the audio spectrum than each band
in the Two-Band structure, the Multi-Band structure will create less spectral gain inter-
modulation when driven heavily. We therefore recommend using the Two-Band struc-
ture for purist jazz, classical or light classical music, or if your goal is to broadcast a
sound that is more faithful to the frequency balances of the original program material
than the sound produced by the Multi-Band structure.
Unlike the Two-Band structures in Orban’s FM processors, the 6200’s Two-
Band structure does not reduce high frequency content because it has no
high frequency limiter. (It is not required because digital broadcasting does
not use pre-emphasis.) Therefore, the Two-Band structure can be very useful
if the broadcaster wants to preserve the spectral balance of the original pro-
gram material. An example might be a “heritage rock” format where the
broadcaster wants to transmit the original frequency balance of a mix that is
very familiar to the audience.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Orban OPTIMOD 6200 and is the answer not in the manual?

Orban OPTIMOD 6200 Specifications

General IconGeneral
BrandOrban
ModelOPTIMOD 6200
CategoryComputer Hardware
LanguageEnglish

Related product manuals