OPTIMOD-AM DIGITAL INSTALLATION
2-43
F) Connect your Ethernet network to the RJ45 jack on the rear panel of your
9300.
If you are connecting to a hub or router, use a standard Ethernet cable.
If you are connecting directly to the Ethernet jack on a computer, use a
“crossover” or “reverse” Ethernet cable.
G) Press the N
EXT button.
2. Prepare the 9300 for modem connection through the serial port:
[Skip this step if you will not be using a modem connection.]
A) Navigate to S
ETUP > NETWORK & REMOTE.
B) Hold down the PC
CONNECT soft button and turn the knob until you see
M
ODEM on the display.
C) Press the M
ODEM INIT soft button.
D) If the string that appears in the display
is S0=4, this is correct. Press the
E
SCAPE button and skip steps (E) and (F) below.
S0=4 is the 9300 default setting. This activates auto-answer functionality
in the modem.
E) Set the InIT STRING to S0=4. Use the NEXT and PREV KEYs to move the cursor in
turn to each character in the modem initialization string. Use the knob to set
the character to the desired value. Repeat until you have set all the characters
in the initialization string.
F) Press the SAVE soft button to confirm your setting.
3. Modem setup:
You will need two modems and two available phone lines, one of each for your
PC and your 9300. Orban Customer Service supports only the 3Com / U.S. Robot-
ics® 56kbps fax modem EXT on the 9300 side of your connection, although other
56kbps modems will usually work OK.
You can use either an internal or an external modem with your PC.
A) Connect the telephone line from the wall phone jack to the wall connection
icon on the back of the modem (modem in).
B) Connect the modem to the 9300’s serial port with a standard (not null) mo-
dem cable.
C) Set the modem to A
UTO ANSWER and turn it on.
For 3Com / U.S. Robotics® 56kbps fax modem EXT, set dipswitches 3, 5,
and 8 in the down position to activate the A
UTO ANSWER setting. All other
dipswitches should be set to the up position.
To Next Page
Loading...
Need help?
General
