59
ATTENTION: When the charger outputs are equipped with protections, a single
connection terminal block will be mounted, and the equipment power terminals
will be replaced by a switch that allows the equipment to be disconnected
independently of the power lines.
NOTE: To make the electrical connection to the charger, the terminal cables
must be used.
Grounding
For correct operation of the charger, it must be considered that the grounding
installation must comply with the following:
The type of ground system of our installation is TT, TN(S), or TN(C).
Voltage between neutral and ground (N-PE) less than 5 Vac
Resistance of the ground installation with less than 50 Ω.
To Next Page
Loading...
