OREC RABBIT RM882 - Page 24

OREC RM881 - © SAT 2021-05-06
24
MAINTENANCE CHART
 Ask your dealer to realize this operation needing special tools and knowledge.
 Inspection to realize by the owners before starting the engine
 Inspection to realize by the owners after starting the engine
Part to inspect
Inspection
Every
use
First 20
hours
Every
100
hours
Every 300
hours or every
year
Blade belt
Check belt tension


Check wear


HST Transmission
Oil level


Oil leak


Oil pollution

Fuel
Refuelling

Fuel cock

Flammables materials
Clean the machine from flammables
materials

Steering wheel
Horizontal, loosness

Lateral loosness

Travel lever
Check machine do not move when
lever is on “N”

Check travel lever goes on “N” when
applying brake

Tyres
Check tires pressure

Check tires wear

Brake
Check efficiency of the brake

Check travel lever goes on “N” when
applying brake

Chassis
Check for rust, and cracks
Safety stickers
Check they are in place and in good
condition

Safety switches
Check for efficiency

Guards & shields
Check they are bolted in their place
and in good condition

Ignition key
Check for efficiency

Tank and fuel hoses
Check for leaks and good condition
Replace if needed

Battery
Check level

Throttle lever
Check for efficiency

Blades
Check they are bolted in their place
and in good condition

Blade clutch control
lever
Check the adjustment of the wire



Blade brake
Check the adjustment



Blade belt
Check they tensionned and in good
condition


Engine
Refer to engine manual