Increase Quality Through Interaction with the Field
Table of Contents
Electrical Page 3
Tune-Up
Evaluate Page 4
Clean Page 4
Replace Page 5
Low Power/Sparks Pages 5 – 6
Wheels Grinding/Rattling/Worn Page 6
Part Replacement/Disassembly
Sole Plate Page 7
Lens/Fascia/Top Cover Pages 7 - 8
Brushroll Page 8
Belt Page 9
Power Supply Page 9
Valve Assembly Pages 10 - 11
Valve Service Pages 11 – 13
Control Board Page 13
Motor Module Pages 14 –15
Motor Pages 15 – 16
Fan Housing Module Page 16
Outer Bag Pages 16 – 18
Grip Pages 19 – 20
Harness Pages 20 – 21
Lifter Pages 21 – 23
Troubleshooting
Valve Stuck in Hose Position Page 23
Valve Stuck in Nozzle Position Pages 24 – 25
Nothing Works Pages 25 – 28
Everything Works But The Motor Page 28
Everything Works But The LED Lights Page 29
Features of the Edge
1. Electronic Motor Speed Control
2. Electronic Motor Stop – If the fan jams the motor will stop which save both the
motor and the belt.
3. Mechanical nozzle lift prevents brushroll contact with the floor surface when
the unit is in the accessory hose mode or locked upright and left running.
4. Electronic Suction Path Valve Control - When the hose is attached and the unit
is upright and locked, the suction path is through the hose. When the unit is
moved from the upright and locked position to the normal use position, the
suction path automatically changes to through the power nozzle. If the hose isn’t
installed then the path stays through the nozzle no matter the position of the unit.
Increase Quality Through Interaction with the Field
2
To Next Page
Loading...
