Oreck Edge - Part Replacement;Disassembly; Sole Plate; Lens;Fascia;Top Cover

Increase Quality Through Interaction with the Field
Part Replacement/Disassembly
(Reverse to Reassemble)
1. Sole Plate
a. Extract 6 screws (#2 Phillips)
b. Remove Edge Brush – Find the round tab (Circled). With a
punch and hammer knock out the edge brush
c. The edge brushes are marked left L and right R. Line up the tab
with the sole plate hole and snap in place
2. Lens/Fascia/Top Cover
a. To remove the fascia the lens must be removed and two screws
extracted. Pry the lens away at one end, bend it out so the end
tab pops free (Picture) and do the same with the tabs along its
length.
Increase Quality Through Interaction with the Field
7