Increase Quality Through Interaction with the Field
4. Belt – Requires Steps 1, 2 & 3
a. Fit the belt to the brushroll pulley. Fit the brushroll/belt assembly
to the base. Feed the belt through the slot (Picture 1). Use a
3/8” or 10mm socket or nut driver (Picture 2) to capture the
motor shaft (Picture 3) and pivot the belt on to it (Picture 4), this
will require that the belt be encouraged onto the motor shaft. Be
sure the belt is centered and fully seated (Picture 5). If the short
socket doesn’t work for you try a deep socket (Picture 6 top) or
a hollow shaft 7/16” nut driver with the head cut off (Picture 6
bottom & Picture 7). Make sure the belt is seated in the brushroll
pulley
1
2
4
3
5
7
6
5. Power Supply – Requires Step 2
a. Unplug from control board and lift out.
Increase Quality Through Interaction with the Field
9
To Next Page
Loading...
