Oreck Edge - Wheels Grinding;Rattling;Worn

Increase Quality Through Interaction with the Field
i. Turn the unit off and unplug from outlet.
5. Wheels Grinding/Rattling/Worn - Rear Wheel Service
a. Remove hubcap – Insert flathead screwdriver blade into one of the
3 slots on the back of the wheel hub. Place the blade as shown in
picture 1 and twist until hub tab has unhooked from the wheel hub
picture 2, then push down.
1
i.
b. Remove wheel – Remove E clip and washer
i.
Washer E clip
c. Remove Axle – Remove 2 screws from the cord over-mold and the
yoke cover (Picture 1). Slide out the axle (Picture 2).
i.
1
Yoke Cover
2
Cord Over-mold
End of Tune-up section
Increase Quality Through Interaction with the Field
6