Oregon Scientific SE338 - Control Buttons and LCD Display; Button Functions; Getting Started with Your Watch; Initial Setup Procedure

EN
2
CONTROL BUTTONS / LCD DISPLAY
1
5
B. MODE/-
2
3
4
6
7
8
E
A. EL
D. ENTER
C. +/ST/SP
1
5
B. MODE/-
2
3
4
6
7
8
A. EL
D. ENTER
C. +/ST/SP
E
1. : key tone deactivated
2.
: key press prompt (touch EL) to activate backlight
3.
: low battery indicator
4.
: key press prompt (touch MODE/-)
5.
: keypad locked
6.
:key press prompt (touch +/ST/SP)
7. Time; heart rate measurements; mode banners;
exercise time / data
8.
: key press prompt (touch ENTER)
A. EL: activate backlight
B. MODE/-: toggle between modes; exit current display and
return to previous screen; decrease value of the setting;
toggle setting options
C. +/ST/SP: start / stop stopwatch; increase value of the
setting; toggle setting options
D. ENTER: enter setting mode; conrm setting; toggle
through displays
E. Bezel: touch to measure heart rate
STARTING YOUR WATCH (FIRST TIME)
To unlock the watch from sleep mode, tap 3 times on
the screen, then press and hold EL and ENTER
simultaneously until display appears. The watch will prompt
you to set your user prole. (Go directly to ‘Set user prole’
section, step 4).
IMPORTANT
• To ensure accurate calculations with your exercise,
you are strongly encouraged to set the watch and user
proles before exercising.
• Remember to set the proles after every battery
replacement or reset.
NOTE When the watch is left idle for 30 seconds during
set up, it will automatically exit the setting mode and display
the time.
TOUCH NAVIGATION
This watch uses TOUCH screen technology – no clumsy
buttons. To navigate through functions, place nger on a
circle (each circle has a different function).
KEY PRESS PROMPTS
MODE/- Enter
EL +/ST/SP
Built-in key press prompts
provide an intuitive user
experience by guiding the
user through settings and
displays.
SE338_EN_EU_R3.indd 2 24/8/2011 15:47:09