Oregon Scientific SE338 - Other Operations and Settings; Battery Replacement

EN
9
watch only allows for all data to be deleted.
To delete memory:
1. Touch MODE/- repeatedly to select “MEM”.
2. Touch +/ST/SP repeatedly until “DELETE” will be
displayed.
3. Touch MODE/- to conrm.
DONE indicates the record has been cleared.
MODE/-
+/ST/SP
MODE/-
When starting an exercise and memory is full, “FULL” will be
displayed, followed by “DELETE”.
• Touch MODE/- to delete all records
OR
• Touch ENTER
to ignore and start an exercise
without recording data for it.
OTHER OPERATIONS AND SETTINGS
ACTIVATE BACKLIGHT
Touch EL. (Touch EL again to extend backlight for another
5 seconds).
NOTE The backlight function will not operate if “ ” is
displayed.
BEEP TONE ON / OFF
When time is displayed, touch +/ST/SP to activate /
deactivate beep tone.
indicates beep tone is deactivated.
REPLACE BATTERY
If the battery power of your watch is low, the watch will
display:
.
To replace watch battery:
1. Use a coin to open the battery compartment lid by
turning it anticlockwise.
2. Remove the old battery and insert a new CR2025, 3V
lithium battery.
3. Secure the lid by turning the coin clockwise.
IMPORTANT Remember to set the proles after every
battery replacement or reset.
SE338_EN_EU_R3.indd 9 24/8/2011 15:47:12