Orgapack OR-T 55 - Page 11

0623 IH-10933VND
11 of 20V 02.22_EN
ORGAPACK OR-T 55
4.2 Setting strap tension
The maximum strap tension is determined by the adjustment of the friction clutch. For this
reason two open-end wrenches are supplied.
► Block the tension shaft on rear side with the
small open-end wrench (SW 11).
► With the other open-end wrench (SW 17)
adjust the nut (friction clutch).
– Turning the nut in clockwise direction the
strap tension is increased.
– Turning the nut in counterclockwise direc-
tion the strap tension is reduced.
Best results are achived by adjusting
the clutch to the maximum tension for
the package being strapped. But not
as tight that the tension wheel will turn
over or the strap breaks.
4.3 Setting welding time
WARNING
Never transport or move packaged goods with improperly performed strapping /
weld sealing - serious injuries may result.
The set welding time is continuously displayed by
means of lled dots (2) when the unit is ready for
operation.
► Press the – (1) or + (3) key until the desired
sealing time is displayed by means of lled
dots (2).
► Carry out seal check after each strapping
(Section 5.2)
17
+
–
1
2
3
H -1 0933