0623 IH-10933VND
16 of 20
V 02.22_EN
ORGAPACK OR-T 55
6 Preventive and corrective maintenance
WARNING
Unexpected startup during maintenance work, injuries possible.
Always remove the battery before performing cleaning or preventive and corrective
maintenance work.
6.1 Preventive maintenance schedule
Task Interval (cycles)
Cleaning the tool (Section 6.2) – Daily (for > 300 strappings/day)
– Weekly (for < 300 strappings/day)
Tool inspection (recommended) – Every 2 years or 50,000 strappings, service
by specialist unit
6.2 Cleaning the tool
In the case of heavy dirt accumulation it is recommended that the tool be cleaned regularly (daily). In
particular, the tension wheel and the tooth plate should be checked for damage and kept clean.
WARNING
Wear eye protection when cleaning
with compressed air!
► Clean the tension wheel (1) and the toothed
plate (2) by blowing them out sideways
with compressed air or with the steel brush
supplied.
► If necessary, replace the tension wheel / tooth
plate (Section 6.3 / 6.4).
6.3 Replacing the tension wheel
Required parts Order number
OR-T 55: Tension wheel (1) (wear part) 1821.047.003
Nut (3) 1820.020.163
Saucer spring (2) Ø25/12,2 x 1,5 1925.210.122
Carrier (1) 1821.255.001
Cluch disk (4) (6) 1830.000.262
Pin (8) 1821.030.024
Dismantling
► Remove battery from tool.
► Block the tension shaft (7) with the open-end
wrench supplied (SW 11). Remove nut (3)
with other open-end wrench (SW 17).
► Remove ve saucer springs (2) and carrier
(1).
► Press tensioning lever and remove pin (8).
► Remove the tension wheel (5) with the two
clutch disks (4) and (6).
H -1 0933
To Next Page
Loading...
