Orgapack OR-T 55 - Page 15

0623 IH-10933VND
15 of 20V 02.22_EN
ORGAPACK OR-T 55
5.3 Setting the strap width
The tools can be operated with the following strap widths:
● OR-T 55: 9–10, 12–13, 15-16 or 19 mm (
3
/
8
″,
1
/
2
″,
5
/
8
″ or
3
/
4
″)
Required parts Order number
Washer (3) 1821.020.042
● To change the strap width, the strap stop (2)
must be removed with the screw (1) from the
tool and retted with washers (1.5 mm thick)
according to the width of the strap.
● Strap width 19 mm (
3
/
4
″): without washer
● Strap width 15–16 mm (
5
/
8
″): one washer
● Strap width 12–13 mm (
1
/
2
″): two washers
● Strap width 9–10 mm (
3
/
8
″): three washers
► Loosen screw (4) and remove knife sleeve (1).
► Remove special screw (2) and move the pawl
(3) to desired position according to strap
width. Tighten special screw (2).
► Insert washers between base plate and knife
sleeve according to strap width.
● Strap width 19 mm (
3
/
4
″): without washer
● Strap width 15–16 mm (
5
/
8
″): one washer
● Strap width 12–13 mm (
1
/
2
″): two washers
● Strap width 9–10 mm (
3
/
8
″): three washers
► Tighten screw (4) again.
PP
PP
PP
PP
PP




PP
PPPP



H -1 0933