Oricom babysense 2 - Control Unit Setup

8
7. Should the design of the cot not allow proper installation with the
control unit holder, please use the supplied hanging hook (as shown in
illustration 6). Hang the control unit from the bottom edge of the cot or
afxthe hook with a screw (not supplied) to the bottom edge of the cot
and hang the control unit from the bottom edge of the cot.
Sensor | Do not use | Sensor
Sensor | Do not use | Sensor
Sensor | Do not use | Sensor
Illustration 6
8. Press control unit holder or hanging hook firmly into slot in back of
control unit as shown in illustration 6 and 7.
Sensor | Do not use | Sensor
Slot
Battery
cover
Blocked socket
DO NOT USE
“Sensor”
socket
Illustration 7
Opening
recess
Speaker
Installation