Oricom babysense 2 - Installation

5
Installation
Installation
1. Remove battery cover by inserting a flat screw driver into the opening
recess and insert, in accordance with the markings, 4 new and
identical size AA 1.5 volt high quality Alkaline batteries, close cover.
Note: Please dispose of used batteries in accordance with local waste
regulations.
2. Make sure the sensitivity adjustor, located on the back of the sensor
pads, is positioned on level 3 as shown in illustration 1.
0
1
2
3
Illustration 1
3. Place control unit holder on the base of the cot and in between two
bars as shown in illustration 2.
Illustration 2
Control unit holder
Cables
Sensor
Sensor