Oricom TPS10 - High Pressure Setting

12
Settings
High Pressure Value Setting:
• Pressthe"
" button to set the high pressure value of the current
interface.
• Press"
" to save and enter the next setting.
Note: When more than 4 sensors are connected you can set the high
pressure value for the individual interfaces (Tow vehicle / Trailer / Spare) to
do this, whilst in the high pressure value setting:
1. Press the "
" button to set the high pressure value of the current
interface.
2. Press and hold the "
" button and press the " ". The image on the
display will change from the tow vehicle to the trailer.
3. Press the "
" button to set the high pressure value for the trailer.
4. Press "
" to save and enter the next setting.
Note: To change the high pressure setting for the Spare Tyre Interface,
repeat steps 2 and 3.
Press "
" button once to enter the next setting.
Psi
Psi Psi Psi
Trailer interface Spare interface
Interface