Oricom TPS10 - Page 19

19
Sensor programming
NOTE:
• Towvehiclesensorscanonlybeprogrammedtothetowvehicleinterface.
DO NOT program Trailer or Spare sensors to tow vehicle interface and
vice versa.
• Sparetyredataisupdatedevery15minutesorifthereisasignicant
change in air pressure.
• Displaydimsandbrightensdependingonthelightconditionssensedby
the solar panel.
• DONOTprogramsensorstoAxleB.
• Thetyredatacanbeclearedbyperformingareset,pressandholddown
both buttons for 3 seconds, the screen should clear the tyre pressure
readings and "--" will appear on the screen. Once driving the tyre
pressures will display automatically.
NOTE: Please visit our website to view tutorial videos on how to
program sensors to the control unit, Visit www.oricom.com.au
select your model and scroll down to the FAQ's section.