11
DCS (Digitally Coded Squelch)
Your UHF088 provides for 104 DCS codes. These are digitally coded
squelch codes which provide additional privacy.
To select a DCS code
1. Press the CTCSS / DCS button twice, DCS oF appears on the
LCD display.
2. Rotate the Channel button or press Up / Down. Select on the Mic to
select the desired DCS channel code.
3. Press the CTCSS / DCS button once to return to standby.
Receive & Transmit Indicator
The LED indictor will illuminate green when the unit is receiving a
signal, when transmitting it will illuminate red. When in standby the
LED is out.
Time Out Timer (ToT)
Australian and New Zealand standards require that if the PTT is
pressed for more than 3 minutes the unit must stop transmitting. The
UHF088 is set to stop transmitting after 2 minutes and 30 seconds of
continous transmitting. After that time the unit will stop transmitting
and TOT will appear in the display to indicate that the ToT has
activated.
Operation
UHF088-UG.indd 11 2012-2-8 15:44:44
To Next Page
Loading...
