Oricom UHF088 - Roger Beep; Beep Tone; Call Tone

17
Roger Beep
Roger beep emits a tone when you release the PTT switch.
1. Press and hold the MENU button for 2 seconds, the display will
show Light
2. Press the MENU button again two times, the display will show
rogEr
3. Rotate the CH control to select between roger beep ON or roger beep
OFF. When roger beep is ON, the note icon appears in the display.
Beep Tone
The Beep Tone emits a tone when you press any of the buttons on the
microphone (except the PTT switch).
1. Press and hold the MENU button for 2 seconds, the display will
show Light
2. Press the MENU button again three times, the display will show
bEEP
3. Rotate the CH control to select between beep tone ON or beep tone
OFF. When roger beep is ON, the note icon appears in the display.
Call Tone
You can select from 5 call tones the tone that is emitted when the Call
button is pressed.
1. Press and hold the MENU button for 2 seconds, the display will
show Light
2. Press the MENU button again four times, the display will show
CALL-1
3. Rotate the CH control to select between the 5 call tones.
Operation
UHF088-UG.indd 17 2012-2-8 15:44:46