Oricom UHF088 - UHF088 Technical Specification

UHF088 Technical Specication
Compliance AS/NZS 4365:2011
Frequency Range TX 476.425 - 477.4125MHz
Frequency Range RX 450 - 512MHz
Number of TX/RX Channels 75 UHF CB
Number user programmable of RX Only
Channels
60
Channel Spacing TX/RX 12.5KHz
Operating modes Simplex, Repeater TX offset (+750kHz)
Wideband scanner bands 450-512mHz
Scanning Speed 250 ms per channel
Antenna Impeadance 50 Ohms
Operating Volts Nominal 13.8 VDC
Operating Volts Range 10 - 15 VDC
Over Voltage Protection Diode and voltage regulator
Over Current Protection 2 Amp fuse
Reverse Polarity Protection Series Diode
Frequency Stability +/- 5ppm
Transmitter
RF Power Output Nominal 5.0 Watts
Modulation F3E (FM)
Maximum Deviation 2.5kHz
Spurious Emissions < -30dBm
TX Audio pre-emphasis +6dB per octave 300Hz to 3kHz
Audio Signal to Noise Ratio > 35dB
Current Consumption during TX 1.6 Amps with 50 Ohm antenna
termination
22
UHF088 Technical Specication
UHF088-UG.indd 22 2012-2-8 15:44:49