15
Operations
The Repeator Access function can be set (from channel 1 to 8 and 41
to 48) used by local repeater stations. When activated, your radio will
receive the Repeator on its specific channel (all repeater outputs are
on channel 1 to 8 and 41 to 48) but transmit to the repeater channel
31 throgh 38 and 71 to 78 (Factory default is set to ON for all repeater
channels).
e.g.
CH01 on Duplex mode will receive on CH01 but transmit on CH31.
CH02 on duplex mode will receive on CH02 but transmit on CH32.
If you transmit on CH01 duplex mode, you are actually transmitting on
CH31; the repeater station down converts your signal and retransmits on
CH01.
Your UHF300 allows you to pre-select Duplex operation individually on
each channel.
CH and Number
Simplex mode Transmit/
reciever Frequency (MHz)
Duplex Mode transmit
Frequency(MHz)
1 476.425 477.175 CH31
2 476.450 477.200 CH32
3 476.475 477.225 CH33
4 476.500 477.250 CH34
5 476.525 477.275 CH35
6 476.550 477.300 CH36
7 476.575 477.325 CH37
8 476.600 477.350 CH38
41 476.4375 477.1875 CH71
42 476.4625 477.2125 CH72
43 476.4875 477.2375 CH73
44 476.5125 477.2625 CH74
45 467.5375 477.2875 CH75
46 476.5625 477.3125 CH76
47 476.5875 477.3375 CH77
48 476.6125 477.3625 CH78
To Next Page
Loading...
Need help?
General
