19
Monitor
1. Press hold the Menu/Monitor button.
If no signal is present. A hissing noise will indicate an empty channel.
2. Press the Menu/Monitor button again to restore to it previous setting.
Scan
The radio SCAN function has the ability to allow programmable channels
to be scanned for groups of users.
When a signal is found, scanning will stop at that channel to allow the
signal to be heard, then resume scanning when the cahnnel is clear
again.
The scan resume time can be set as an optional pause of p5(default).
1. Press Scan button and scanning will start. The scan dirction can be
changed at any time by rotating the channel selector left or right.
2. To deactivate Scan, press Scan again.
Memory On/Off
1. Press and hold Scan/Mem button to store.
“•” will appear above the selected channel and short tone is heard.
2. To remove the channel from SCAN memory, press and hold Scan/
Mem button once again. The “•” icon disappears.
Operations
To Next Page
Loading...
Need help?
General
