1 Introduction
−3−
• For Low Voltage Directive
• Since this product is based on 24 VDC power supply input, it is outside the
application scope of Low Voltage Directives.
• When applying the equipment incorporating this product to the Low Voltage
Directive, connect the driver power supply input to the DC power supply where
the primary and secondary sides are provided with reinforced insulation.
• Install this product in the equipment built-in type enclosure.
• Enclosure classification
Motor: IP65 (Lead wire type: IP40)
Driver: IP00
• For EMC Directive
This product has received EMC measures under the conditions specified in
“Example of motor and driver installation and wiring” on page28. Be sure to
conduct EMC measures with the product assembled in your equipment by referring
to 5.9 “Installing and wiring in compliance with EMC Directive” on page 25.
Hazardous substances
RoHS (Directive 2002/95/EC 27Jan.2003) compliant
To Next Page
Loading...
