Oriental motor BLHD100K - Safety Precautions for BLH Series; General Safety Guidelines

2 Safety precautions
−4−
2 Safety precautions
Only qualified personnel should work with the product.
Use the product correctly after thoroughly reading the section “Safety precautions”.
The precautions described below are intended to prevent danger or injury to the user
and other personnel through safe, correct use of the product. Use the product only
after carefully reading and fully understanding these instructions.
Warning
Handling the product without observing the instructions that
accompany a “Warning” symbol may result in serious injury or death.
Caution
Handling the product without observing the instructions that
accompany a “Caution” symbol may result in injury or property
damage.
Note
Note
The items under this heading contain important handling instructions
that the user should observe to ensure safe use of the product.
Warning
General
• Do not use the product in explosive or corrosive environments, in the presence of
flammable gases, locations subjected to splashing water, or near combustibles.
Doing so may result in fire or injury.
• Assign qualified personnel the task of installing, wiring, operating/controlling,
inspecting and troubleshooting the product. Failure to do so may result in fire,
injury or equipment damage.
• When the driver’s protection function is triggered, first remove the cause and then
clear the protection function. Continuing the operation without determining the
cause of the problem may cause malfunction of the motor, leading to injury or
damage to equipment.
Installation
• Install the motor (gearhead) and driver in their enclosures in order to prevent
injury.
Connection
• Keep the driver’s power supply input voltage within the specified range to avoid
fire.
• Connect the cables securely according to the wiring example in order to prevent
fire.
• Do not forcibly bend, pull or pinch the cable. Doing so may result in fire.
• For the driver’s power supply use a DC power supply with reinforced insulation
on its primary and secondary sides. Failure to do so may result in electric shock.