2 Safety precautions
−6−
• Before moving the motor directly with the hands (as in the case of manual
positioning), confirm that the driver operation input is “OFF” to prevent injury.
• Do not perform the motor’s starting and stopping operations by turning the power
supply on and off. Perform them by inputting START/STOP and RUN/BRAKE.
This may cause injury or damage to the equipment.
• The motor’s surface temperature may exceed 70 °C, even under
normal operating conditions. If a motor is accessible during
operation, post a warning label shown in the figure in a
conspicuous position to prevent the risk of burns.
Warning label
Disposal
• To dispose of the motor, gearhead and driver disassemble it into parts and
components as much as possible and dispose of individual parts/components as
industrial waste.
To Next Page
Loading...
