To Next PageTo Next PageHow to troubleshoot an Oriental motor CRK Engine that is not energized?
If the Oriental motor Engine is not energized and its output shaft turns easily, there could be a few reasons. First, check all connections between the driver, motor, and power supply to ensure they are correctly connected. Next, verify that the current potentiometer is at its factory setting. Finally, make sure the A.W.OFF input is set to “OFF” to ensure the motor is excited.
What to do if the Oriental motor CRK Engine is too hot?
If the Oriental motor Engine is overheating, there are a few potential causes. The motor may be experiencing long continuous operation, in which case you should decrease the operation time per session or increase the standstill time. Also, check if the C.D.INH input is set to ON and switch it to OFF. Finally, the motor standstill current adjustment might be too high; adjust it to 50% of the operating current or below.
What to do if the Oriental motor CRK Engine does not run?
If the Oriental motor Engine does not run, check the pulse input line connection between the controller and driver. Also, the current potentiometer might be incorrectly set; return it to its factory setting and check. If the CW and CCW inputs are ON simultaneously, input either the CW or CCW input, and switch the other terminal to OFF.
Why is the Oriental motor CRK Engine vibration too great?
Excessive vibration in the Oriental motor Engine can be caused by a few things. Check the connection condition of the motor’s output shaft and load shaft to ensure they are aligned. If the vibration decreases when the operating pulse speed is changed, it could be due to motor resonating. Also, if the load is too small, try lowering the motor operating current.
What to do if the Oriental motor CRK is not energized?
If the Oriental motor Engine is not energized, first, check for connection errors in the motor leads or power supply cable between the driver, motor, and power supply. If the current potentiometer is incorrectly set, return it to its factory setting and check. Also, verify that the A.W.OFF input is set to OFF to ensure the motor is excited.
What to do if the Oriental motor CRK does not move the set amount?
If the Oriental motor Engine does not move the set amount, check the C/S input switching state. Also, check the settings of the step angle setting switches [DATA1] and [DATA2]. Finally, check whether or not the number of pulses required for operation at the set step angle are being output; the pulse output count may be too low or too high.
Why is my Oriental motor Engine too hot?
If an Oriental motor Engine is too hot, it could be due to several reasons. First, reduce the motor's continuous operation time or increase the standstill time, ensuring the motor case temperature does not exceed 100 °C (212 °F). Second, verify the current cutback release input is set to “OFF.” Third, adjust the motor’s standstill current to one-half of the operating current or below.
What to do if Oriental motor CRK loses synchronization during acceleration?
If an Oriental motor Engine loses synchronization during acceleration or running, several factors could be the cause. First, check the alignment of the motor's output shaft and the load shaft. Second, examine the load for significant fluctuations; adjusting the motor's speed to low or high torque may help identify load-related issues. Third, reduce the starting pulse speed to ensure stable starting. Fourth, increase the acceleration or deceleration time. Lastly, check for electrical noise by running only the essential components and implement noise countermeasures if necessary, such as rewiring, using shielded cables, or installing a ferrite core.
What to do if the Oriental motor CRK TIMING output is not output?
If the Oriental motor Engine TIMING output is not output, switch the C/S input when TIMING output is ON.
Why is the Oriental motor CRK driver too hot?
If the Oriental motor Engine driver is too hot, it may be due to long continuous operation of the motor. Decrease the operation time of the motor per session or increase the standstill time.
General| Brand | Oriental motor |
|---|---|
| Model | CRK Series |
| Category | Engine |
| Language | English |
