46
PERSONAL PROTECTIVE EQUIPMENT RECOMMENDATIONS FOR FLYING SPARKS AND
ARC RAYS
It is essential for every person in the immediate work area to wear/utilize proper
personal protection equipment. ere is a possibility that sparks can fly off from the weld
joint area; therefore, take the necessary precautions to avoid trapping a spark within your
own clothing.
• Wear protective garments such as oil-free, flame-resistant leather gloves, heavy shirt, cuff-less
trousers, high shoes, and a cap. Avoid synthetic fibers as they melt easily.
• Use an approved face shield or safety goggles with side shields when welding or when observing
others performing welds.
SAFETY PRECAUTIONS FOR HOT METAL AND CABLES
Welding material that has a high thermal conductivity will cause metal to heat rapidly. Repetitive welds in
the same location can also cause metal to heat rapidly.
• Avoid touching weld spots immediately after the weld has been performed as
they will be hot.
• Do not touch hot weld areas barehanded.
• Allow sufficient cooling time before handling welded pieces.
• Welding cables can become extremely hot. After extended use, be cautious when handling the
weld cables.
SAFETY PRECAUTIONS FOR FUMES AND GASES
Welding can produce fumes and gases. Breathing these fumes and gases can be hazardous to your
health. Sunstone weld heads produce minimal fumes and gases when compared to large-scale weld
heads. ough not required, some form of ventilation is recommended.
• Keep fumes away from face.
• Do not breathe the fumes.
• Ventilate the area and/or use local forced ventilation at the weld spot to remove
welding fumes.
• If ventilation is poor, wear an approved air-supplied respirator.
• Read and understand the Material Safety Data Sheets (MSDS) and the manufacturer’s instructions
To Next Page
Loading...
Need help?
General
