INTERNAL CROSSOVER SECTION
The crossover section of the HCCA amplifier is continuously variable and ex-
tremely flexible. There are eight different crossover configurations possible allow-
ing high-pass, low-pass and band-pass configurations. New for ORION amplifiers is
the INTELLi Q feature on the high-pass crossover. This circuit is designed to opti-
mize the performance of ORION subwoofers in all types of enclosures.
When using ORION loudspeakers, minor deviations from the recommended frequency ranges can provide superior results depend-
ing on your speaker locations and your vehicle acoustics. Setting crossover frequencies higher than recommended will not cause
damage and may provide superior sonic results depending on your system’s performance goals. Refer to your loudspeaker owner’s
manual for assistance in choosing the proper crossover frequencies for your system.
WARNING!!! DO NOT set crossover frequencies lower than the speakers recommended operating range. This can cause driver
failure that is not covered by manufacturer’s warranty.
LOW-PASS CROSSOVER
When the push When the push
button is in the button is in the
“out” position, “in” position,
the low-pass the low-pass
crossover is bypassed. crossover is active.
The low-pass
crossover is
continuously variable
from 45 Hz to 5 kHz.
page 34
To Next Page
Loading...
Need help?
General
