INSTALLATION TIPS
TOOLS FOR THE TRADE
Listed are the majority of the tools required to perform the installation. Having the proper tools will make the installation that
much easier. Some of these tools are necessities. Some make the job much easier.
• marking pen • heat shrink tubing
• electric drill with assorted drill bits • nylon tie straps
• utility knife • volt-ohm meter (optional)
• Phillips and flat blade screw drivers • wire cutters
• pliers (standard and needle nose) • wire crimpers
• wire brush or sandpaper for chassis grounding • wire strippers
• solder iron and solder • RTA (real time analyzer)
• grommets • Reference CD with 1 kHz Sine Wave at 0dB level
(all bits high)
page 44
To Next Page
Loading...
Need help?
General
