Machine Manual Orion
Flex Stretchwrapper Revision 3.0
System Operation 15 February 2016
Page 3-48
Information & Alarm Messages
The message and alarm displays are divided into two separate charts in this section.
• Message Displays - Various non-critical status messages
• Alarm Displays - Operation critical alarms/faults
Message Displays
The messages in this section are the various non-critical status messages. These messages
are for informational purposes. For critical alarms, see “Alarm Displays” on page 3 - 52.
Note:
Not all messages in this list are applicable to your machine. The
alarm messages on you machine may vary based on machine
options.
Table 3-33. The Information and Alarm Displays
MESSAGE DESCRIPTION CORRECTION
MACHINE SETUP
REQUIRED - SELECT
MACHINE OPTIONS
The machine setup parameters are not set.
See “Machine Setup Screen” on
page 3 - 26.
APPLYING TOP
WRAPS The machine is currently applying the top wraps.
This is for informational pur-
poses only. No correction neces-
sary.
END OF FILM ROLL
OR BROKEN FILM
The film has broken or the roll ran out.
Re-load a new roll if out. If bro-
ken, monitor the film. Replace
roll if problem persists. See trou-
bleshooting chart for broken film
troubleshooting tips.
CYCLE ENDING
The cycle is ending.
This is for informational pur-
poses only. No correction neces-
sary.
CYCLE PAUSED
The cycle is paused.
Resume, when ready. Press the
resume button on the Run
screen.
E-STOP PRESSED
The E-stop button is currently pressed.
Release the E-stop button to
allow operation. Press Start to
reset control power, then press
and hold start for the amount of
time set up in the parameters.
To Next Page
Loading...
Need help?
General
