52
5. Touch-Tone Remote Control
Introduction
When the control panel is fitted with a PSTN module, the system can be remotely controlled
via any touch-tone telephone. Once the call is answered by the control panel you will be
assisted by voice prompts to enter your normal access code, if the code is accepted a voice
prompted menu is played to you. From the main menu, you can arm and disarm the system
and turn outputs on and off.
Remote Control Menu
Remote Access
To gain remote access to your security system, please proceed as follows:
1. From any touch-tone telephone, first dial the number of your premises. If your premises
have more than one line, be sure to call the number of the line on which your control
panel has been installed. After a single ring, hang up, wait 10 seconds, and call again. On
the second call, the system will answer after one or two rings and announce:
“Enter passcode”
2. Enter your normal access code via the touch tone phone. The system will then prompt
its current armed status:
“System disarmed” or “System armed” or “System part armed”
3. The main menu is prompted:
“Press 4 to full arm, press 1, 2 or 3 to part arm, press * to hear again.”
4. Enter the function command (see remote control menu).
To Next Page
Loading...
