What to do if my Orisec Intercom System shows an AC Fail error?
If your Orisec Intercom System displays an AC Fail error, it means the main power to the control panel has been disconnected or lost. Check to ensure there is not a power cut, or contact the installation company.
Why does my Orisec CK-20 show a Battery Fault?
A Battery Fault on your Orisec Intercom System indicates that the main panel battery has a low voltage or has been removed. The internal battery should be replaced every 2-3 years.
What to do if my Orisec CK-20 Intercom System displays 'Zone 01 Alarm'?
If your Orisec Intercom System displays 'Zone 01 Alarm', it means that the zone has recently been alarmed and is awaiting a reset. Enter your user code and select ‘Reset Alarms’.
Why is my Orisec Intercom System showing 'Zone 01 Active'?
If your Orisec Intercom System shows 'Zone 01 Active', the zone is reporting back to the main control panel an open state. Check the device to ensure it is not a door or window that has been left open.
What to do if my Orisec Intercom System displays a tamper error?
If your Orisec Intercom System displays a tamper error, it means the device's lid is not making contact properly. Check the lid of the device to ensure it is securely fastened.
What does 'Zone 01 Masked' mean on my Orisec CK-20?
If your Orisec Intercom System displays 'Zone 01 Masked', it means the zone is reporting that an object is potentially obstructing its view. Check the area where the detector is located for anything that may be obstructing the detector.
How to fix a 'Zone 01 Tamper' error on my Orisec CK-20?
If your Orisec Intercom System displays 'Zone 01 Tamper', it indicates that the zone's lid is not making a tight connection. Check the lid of the device to ensure it is securely fastened.
What does 'Omitted Zones' mean on my Orisec CK-20?
If your Orisec Intercom System displays 'Omitted Zones', it means that a user has manually disabled certain zones from operating on the system. Ask an installer or master user to help reinstate the zones if required.
What should I do if my Orisec CK-20 Intercom System prompts me to 'Confirm Devices'?
If your Orisec Intercom System prompts you to 'Confirm Devices', it means a networked device on the security system has been removed. Contact the installation company.
What to do if Orisec Intercom System shows AC Fail?
If your Orisec Intercom System displays an AC Fail message, it means the main power to the control panel has been disconnected or lost. Check to ensure there isn't a power cut, or contact the installation company.
Describes the system's communication with an Alarm Receiving Centre (ARC).
Defines zones as inputs and areas as groupings of zones for arming.
Explains the function and types of access codes for system operation.
How NFC tags function as access codes on compatible keypads.
Introduces the keypad's three emergency functions.
Instructions for putting the system into full arm mode.
Instructions for putting the system into part arm mode.
Steps to disarm the security system.
Procedure to reset the system after an alarm event.
Procedure to reset the system after a fault condition.
Steps to change a user's access code.
Managing system users and their access levels.
Troubleshooting zone-specific faults and tamper conditions.
Troubleshooting general system faults like AC fail or battery.
General| Brand | Orisec |
|---|---|
| Model | CK-20 |
| Category | Intercom System |
| Language | English |
To Next Page
