To Next Page

To Previous Page

6. COMMANDS AND RESPONSES

DISABLE_GAIN_STABILIZATION

Stops stabilization of the gain peak while data is being acquired. The gain stabilization

adjustment is held at its current value until either gain stabilization is reenabled with the

ENABLE_GAIN_STABILIZATION command or reinitialized with the

INITIALIZE_GAIN_STABILIZATION, SET_GAIN_PEAK or SET_GAIN_WIDTH

command. See also SHOW_GAIN_STABILIZATION.

DISABLE_HV

Turns off the high-voltage output on the rear panel of the DSPEC. Note that with no external

load on the high-voltage output it takes approximately 60 seconds for the high voltage to

drop to zero volts. See the section on the bias supply for more information about the high-

voltage output. See also ENABLE_HV and SHOW_HV.

DISABLE_OVERFLOW_PRESET

Disables the overflow preset for the currently selected device (see SET_DEVICE command).

Channels that receive a count when they contain 2147483647 counts, the maximum number

of counts, will roll over to zero counts if the overflow preset is disabled. See also

ENABLE_OVERFLOW_PRESET and SHOW_OVERFLOW_PRESET.

DISABLE_PZ_AUTOMATIC

Disables the automatic pole zero mode. See also ENABLE_PZ_AUTOMATIC.

DISABLE_REMOTE

Disables the recognition of commands on the alternate communication paths. If this

command is sent to the DSPEC via the mailbox communication path, it disables command

recognition on the serial path. If this command is sent via the serial path, it disables

command recognition on the mailbox communication path. See also ENABLE_REMOTE

and SHOW_REMOTE.

DISABLE_THRESHOLD_AUTOMATIC

Disables automatic positive and negative threshold determination. See

ENABLE_THRESHOLD_AUTOMATIC, SET_THRESHOLD_NEGATIVE, and

SET_THRESHOLD_POSITIVE.

DISABLE_THRESHOLD_SAMPLE

Allows InSight Oscilloscope to free-run without a trigger. See

ENABLE_THRESHOLD_SAMPLE and SET_THRESHOLD_SAMPLE.

DISABLE_ZERO_STABILIZATION

Stops stabilization of the zero peak while data is being acquired. The zero stabilization

adjustment is held at its current value until either zero stabilization is reenabled with the

ORTEC DSPEC User Manual

Questions and Answers: