DSPEC
®
Digital Gamma-Ray Spectrometer
52
SHOW_OVERFLOW_PRESET
Reports the state of the overflow preset.
Responses:
$IT<CR>
Overflow preset enabled.
$IF<CR>
Overflow preset disabled.
SHOW_PAGE
See also SET_PAGE.
Responses:
$A001246
Page number 1.
SHOW_PEAK
This command returns the contents of the ROI channel with the largest number of counts. An
ROI channel is a channel that has the ROI flag set. The maximum possible value is
2147483647, which is the maximum number of counts that can be stored in a 31-bit channel.
Responses:
$G0000000000075<CR>
Maximum count in an ROI channel is zero or no ROI
channels were found.
$G0000000001076<CR>
Maximum count in an ROI channel is 1.
... ...
$G2147483646120<CR>
Maximum count in an ROI channel is 2147483646.
$G2147483647121<CR>
Maximum count in an ROI channel is 2147483647.
SHOW_PEAK_CHANNEL
This command returns the number of the ROI channel with the largest number of counts. An
ROI channel is a channel that has the ROI flag set. The lowest number ROI channel with the
largest count is reported if more that one channel contains the largest number of counts.
Channel 16383 is the highest numbered channel in any device.
Responses:
$C00000087<CR>
Maximum count was found in channel 0 or no ROI channels
were found (see errors below).
$C00001088<CR>
Maximum count was found in channel 1.
... ...
$C16382107<CR>
Maximum count was found in channel 16382.
$C16383108<CR>
Maximum count was found in channel 16383.
SHOW_PEAK_DELAY
Reports the Peak Delay setting. See also SET_PEAK_DELAY.
Responses:
$A003248
Peak Delay = 3.
To Next Page
Loading...
