9
Connect Control’s
Black Wire to
AC Power
Organize Wire Lead If necessary, use the tie wrap to tie back the temperature
detector wire lead and the control’s wiring harness to ensure
they do not interfere with the draft fan and other grill
components.
Attach Hopper If your grill is equipped with a hopper bottom panel, attach
Bottom Panel the panel, install and tighten the screws.
Testing the Grill
Prepare the Grill Set the Cook Control to the Off position. Open the cook lid
and remove the internal grill, the drip pan, and the heat
baffle to expose the firepot.
Turn the Grill On Plug the grill's AC power cord into an outlet. Turn the Cook
Control switch to the Smoke position.
Check the Draft Fan Place your hand above the firepot and verify air movement
from the draft fan.
Check the Igniter Verify the igniter located in the base of the firepot is getting
hot. DO NOT TOUCH THE IGNITER!
Check the Fuel Auger Verify that pellets are flowing into the firepot. If the pellet
hopper is empty, open the hopper lid, look inside the hopper
and verify the auger is turning.
Turn the Grill Off Set the Cook Control to the Off position.
Reassemble the Grill If the grill passes the tests above, reassemble the grill. If
not, refer to the "Troubleshooting" section of this manual.
AC Power Plu
To Next Page
Loading...
Need help?
General