3
Installation
Removing the Old Control
Required Tools Medium Phillips screwdriver
Small slotted screwdriver
Unplug the Grill Unplug the grill from AC power.
WARNING: AC power is present on the control at all
times and is a shock hazard unless the grill is
disconnected from the wall socket or AC line.
Remove Hopper Some grills are equipped with a protective panel mounted
Bottom Panel below the hopper. This panel protects grill components
while allowing air to flow into the draft fan. Remove the
screws and panel from the grill, slide the panel down the
power cord, and set aside.
Disconnect the Working under the grill, locate the control’s wiring harness.
Control Disconnect all four plugs that connect the control to the
grill’s components (fuel feed auger, draft fan, igniter, and AC
power).
Remove the Control Remove the faceplate screws using a medium Phillips
screwdriver. Save the screws for use later. Gently pull the
control forward, rotating it slightly to the right. Once clear,
pull the wire harness up and out of the cutout.
To Next Page
Loading...