4
Disconnect the If you are removing a Traeger Digital Control, you must
Temperature disconnect the temperature detector. Turn the control until
Detector the circuit board is facing you. Using a small slotted
screwdriver, disconnect the temperature detector lead wires
from the two-terminal connector J1 located in the upper
right hand corner of the printed circuit board.
Remove the If you are replacing a Traeger Digital Control, the
Temperature temperature detector is compatible with the RealTemp
Detector TR-100. Replacing it is optional. For best results, we do
recommend replacing the temperature detector, especially
when installing the TR-100 as a service replacement.
Open the cook lid and remove the internal grill and drip pan.
Locate the temperature detector. Using a medium Phillips
screwdriver, loosen its mounting screw and nut. Lift the
detector and feed its wire leads up and out of the grill.
Temperature
Detector
To Next Page
Loading...
Need help?
General