12
Connecting the Grill to AC Power
Turn the Grill Off Set the Cook Control switch to the Off position.
Plug the Grill In Connect the grill to AC power. The control displays its
model number and software version.
If you see “ErP” If the Cook Control switch is in the Smoke position or any
temperature setting when the grill is plugged in, the control
will display “ErP”, indicating an inadvertent start error. The
standard ignition sequence is halted. This feature prevents
an inadvertent start. To clear the error, set the Cook
Control switch to Off.
Igniting the Grill
Cook Control To ignite the grill, open the grill lid and set the Cook Control
switch to the Smoke position. The grill will begin to smoke
once the pellets are ignited. When you see smoke, shut the
grill lid and turn the Cook Control switch to your desired
setting. Allow the grill to warm up for 15 minutes before
adding food or making any other changes.
Ignition Sequence The draft fan turns on.
The igniter turns on.
The fuel feed auger turns on and delivers fuel continuously
for two minutes.
The grill temperature is displayed along with three flashing
dots signifying that the igniter is on.
The igniter will turn off when one of the following three
conditions is met:
- The igniter has been on for four minutes and the grill
temperature has increased by 30 degrees.
- The igniter has been on for four minutes and the grill
temperature is greater than 150 degrees.
- The igniter has been on for five minutes.
Once the igniter turns off, if the Cook Control switch is set to
the Smoke position, the grill operates in Smoke Mode. If the
Cook Control switch is set to a temperature setting, the grill
operates in Cook Mode. The flashing dots are turned off.
To Next Page
Loading...
Need help?
General