wire into the appropriate + and - terminals on the SMP200. Be sure there are no loose
SUB OUT (SMP200)
Input on the SMP200.
INPUT (SMP200)
Volume Controls and output as an amplified subwoofer channel via the SMP200 Sub OUT.
LINE LEVEL INPUT CONFIGURATION
In this configuration, the line level audio input will be processed by the Crossover, Phase and
NOTE: Do not connect the AC power cord or turn the amp on until all connections have
been made and confirmed. Making connections with the power on can result in...well...
undesirable circumstances...that may not be covered under the factory warranty.
1. Using a stereo or mono RCA-RCA cable with gold ends, connect the LFE OUT, Sub OUT, or
other line level audio OUT on an amplifier, surround receiver or other audio preamp to the
SPEAKER LEVEL IN
1. No connection needed.
SPEAKER LEVEL OUT
1. No connection needed.
1. Use16AWG (min) 2-conductor stranded speaker wire for subwoofer connection
2. Strip approximately 1/2 to 3/4 of an inch off the ends and twist the strands together so
there are no loose strands that can cause shorts.
3. While observing proper wire polarity, insert the stripped and twisted ends of the speaker
strands that can cause shorts.
4. Confirm connection and polarity.
5. Connect the speaker wires to the appropriate + and - terminals on the subwoofer.
6. Confirm connection and polarity.
TRIGGER
1. Using a 2 circuit 3.5mm mini plug, connect +12 to 24VDC from the trigger device to the
striped wire (tip). Connect GND from the trigger device to the unmarked wire (sleeve).
AC MAINS
1. After all connections have been made connect the supplied AC Power Cord to an
unswitched AC power outlet.
CONNECTION
To Next Page
Loading...
Need help?
Audio Specifications
Weight and Dimensions
