oset MX-10 2017 - Battery Charging Procedures; Charging Instructions and Best Practices

23
• Ensure that the key switch on your OSET is switched OFF & the baery discharge plug is
disconnected before connecng the charger to the baery’s charge port (see guide below).
• Carefully align the connector pins and connect the charger to the baery by plugging the
connector into the charger receptacle. Twist the lock ring to secure the charger lead to the
baery.
• Plug the charger into the wall outlet.
• Switch the charger on.
• LED Indicaons:
- The LED will illuminate RED when the charger is plugged into a wall outlet.
- The Indicator LED will illuminate YELLOW while the charger is charging the baery.
- The Indicator LED will change to GREEN when the baery is fully charged.
• When charging is complete (the Indicator LED is GREEN), switch the charger o, then
carefully unplug the charger from the wall socket, then from the baery by twisng the lock
ring and pulling the connector out of the charging port.
• Reconnect the baery to the bike and your OSET electric bike is now ready for use.
Charging Port Discharging Port OSET Charger
CHARGING INSTRUCTIONS
Use only the supplied baery charger. If you use any other baery charger, you will void
the warranty, you may damage the baeries and you could cause a re that would result
in property damage and possible injury or death.
WARNING!
Diagnosc Port (for use by OSET Technicians only)
This instrucons only apply to bikes supplied with an ocial OSET lithium baery pack &
charger. For bikes supplied with other baeries, please see the suppliers instrucons for
baery removal & charging.
24
• It normally takes up to seven hours to charge your baeries from a fully discharged
condion. Never overcharge. Remove from the charger aer 7 hours maximum.
• Fully charge the baeries before using your OSET electric bike for the rst me. 7 hours
maximum.
It is recommended that you fully charge the baery before & aer every ride and that
baeries are never le in a discharged state.
Always connect the charger to the bike before connecng the charger to the AC power
source.
Always disconnect the AC power source from the wall socket before disconnecng the
charger from the bike.
To avoid damage to the charger, never subject it to intense physical shock or severe vibraon.
Improper use of the baery charger can result in a re with property damage and
physical injury or death.
WARNING!
Do not block the fan vent on the charger while charging the baery. This can cause the
charger to overheat.
CAUTION
The baery charger supplied with this baery is for INDOOR use only.
CAUTION
Avoid any contact with water or other uids while charging the baery. If the baery,
charger or any connecons become wet, immediately unplug the charger and thoroughly
dry all components prior to charging the baery.
CAUTION
IMPORTANT NOTES ABOUT CHARGING