OTE BCP2-850 - Fig. 1.2: Battery Charger Plate; Tab. 1.2: Battery Charger Versions

Battery charger for the PUMA T2 hand-held radio
Technical Manual
General information and safety recommendations
Page 4 OTE Proprietary Information
P/N: 779-0357/02
Revision 04
Every battery charger is provided with a an anti-tampering plate, placed on the
bottom of the equipment. There you can find the main data of the equipment and
the CE mark.
For example, the BCU2-1500 and the BCU6-750 plates in fig. 1.2 are reported.
Fig. 1.2: Battery charger plate
In tab. 1.2 there are summarized the main features of the five different versions of
the battery charger; in the following paragraphs there will be pointed out the
differences.
Tab. 1.2: Battery charger versions
Version P/N
Charging
slots
Battery Supply
BCP2-850 774-0282/01 2 NiCd, NiMH 230 V (50 Hz)
BCP6-850 774-0283/01 6 NiCd, NiMH 230 V (50 Hz)
BCU2-1500 774-0379/01 2 NiCd, NiMH, Li-Ion 230 V (50 Hz)
BCU2-1500/B 774-0404/01 2 NiCd, NiMH, Li-Ion 230 V / 115 V
(50 Hz/60 Hz)
BCU6-750 774-0396/01 6 NiCd, NiMH, Li-Ion 230 V / 115 V
(50 Hz/60 Hz)