OTE BCP2-850 - Page 7

To Next Page

To Previous Page

Battery charger for the PUMA T2 hand-held radio

Technical Manual

List of figures

P/N: 779-0357/02

Revision 04

OTE Proprietary Information

Page vii

List of figures

Fig. 1.1: Battery charger ..................................................................................................................3

Fig. 1.2: Battery charger plate .........................................................................................................4

Fig. 1.3: BCP6-850 battery charger.................................................................................................5

Fig. 1.4: Two slot battery charger....................................................................................................6

Fig. 2.1: TETRA Network Architecture ..........................................................................................17

Fig. 3.1: BCP2-850 ........................................................................................................................21

Fig. 3.2: BCP6-850 ........................................................................................................................22

Fig. 3.3: Battery charger light signalling ....................................................................................... 23

Fig. 3.4: Battery charger and fast discharging button (details) .....................................................24

Fig. 3.5: BCP2-850 block diagram ................................................................................................26

Fig. 3.6: Battery contacts............................................................................................................... 28

Fig. 3.7: Side cover........................................................................................................................ 29

Fig. 3.8: BCU2-1500, BCU2-1500/B and BCU6-750 block diagram.............................................32

Fig. 4.1: Battery charger positioning..............................................................................................36

Fig. 4.2: Power supply voltage value selection for BCU2-1500/B and BCU6-750........................ 36

Fig. 4.3: PUMA T2 terminal in charge ...........................................................................................37

Fig. 6.1: The battery charger shows no power voltage presence ................................................. 45

Fig. 6.2: The battery charger doesn’t charge the battery correctly even tough it shows

the correct light signalling................................................................................................46