30
HYDROFIT™ Owner’s Information Manual
WARNING: The use and ownership of this work is defined in the legend upon the front page hereof.
Anti-Nuisance
If an excessive number of car calls are registered, the elevator will determine
whether calls should be canceled. This is a function of passenger load and
predetermined weight settings.
Automatic Car Return Operation
Automatic Car Return Operation causes the car to park at a specified landing when
there is no further demand. The car parks at the specified Automatic Car Return
Landing whenever the car becomes idle. The operation is keyswitch activated, and
overrides normal zoned parking. The car can be pre-programmed to park at the
automatic car return position with its doors open.
Auxiliary Car Operating Panel
An Auxiliary Car Operating Panel is a second car operating panel, usually located on
the opposite side of the main car operating panel on elevators with center opening
doors. If an elevator has two openings, the rear opening is designated as the
auxiliary car operating panel.
Call Parking Recognition
With Call Parking Recognition, doors only open in response to car and hall demand.
Cars parked without a demand are parked without door operation.
Car Buttons—Illuminated
Car Fixtures employ mechanical LED illuminated buttons.
Direction Preference
Direction Preference is given to the hall passenger that registers a car call for the
original direction of travel before the doors close. The elevator will not reverse
direction for a passenger waiting at another floor.
Direction Reversal
A car without registered car calls arriving at a floor where both up and down hall
calls are registered will first respond to the hall call in the direction that the car was
traveling. If no car call is registered for further travel in that direction, the car will
close its doors and immediately reopen them in response to the hall call in the
opposite direction. The hall lantern always shows the direction the car will travel
when it leaves a floor.
Emergency Exit Contacts
This feature consists of safety chain contacts for top emergency exits. The feature
prevents the car from moving when the car top exit is open.
Fan and Light Sleep Mode
The cab’s fan and light automatically turn off if the car is idle for a set period of time
to save energy.
To Next Page
Loading...