36
HYDROFIT™ Owner’s Information Manual
WARNING: The use and ownership of this work is defined in the legend upon the front page hereof.
remain open until the door close button is activated. When the Phase II keyswitch is
in the hold position, the car parks with its door open, the door closed button is
disabled, and car calls cannot be registered.
Anti-Crime Protection
Anti-Crime Protection, when activated, forces each car in the group to stop at a
predetermined floor and open its doors. This allows a security guard or others at the
floor to visually inspect the passengers of the elevator before the car completes its
run.
Car Secure Access
This feature allows each car call button to be secured or cleared. If a car call button
is secured, it will not register a call unless a landing access code is correctly entered
on the car operating buttons within a predetermined time period after the secured
car button is pressed. Selection and changing of the landing access codes is done
on each car operating panel using the Car Secure Access keyswitch. Activation of
Car Secure Access is done using the Group Secure Access keyswitch located in the
hall or lobby. Activation illuminates the “Group Secured” lamp located in the
hallway. A car call to a secured landing illuminates the “Restricted Landing” lamp in
the car’s cab car operating panel. It remains illuminated for a set time period, or until
a valid landing access code is entered.
Landings that are secured by Car Secure Access are available when the car is operating
under Independent Service Override (optional) or Firefighter’s Service Phase II.
Car Secure Access is activated by a 3-position keyswitch located in the car
operating panel. The three positions are CLEAR, SECURE, and an unlabeled
position. The “Restricted Landing” lamp accompanies this switch.
Card Reader in Car
When car card reader security is activated, car calls to restricted landings do not
register. When a passenger inserts a valid card into the card reader, they are
allowed to register a car call to selected restricted landings. Car Secure Access,
Express Priority Service, and Firefighters’ Service Phases I and II, override the Card
Reader in Car operation. Independent Service operation may selectively override
Card Reader in Car operation.
Card Reader in Hall
When the Card Reader in Hall operation security is enabled, a valid card read by the
reader is needed to register a hall call. Connections for Card Reader in Hall security
are part of the elevator’s hall link communication network. This allows a card reader
mounted in the lobby, or the implementation of a card reader-type security, to use
keyswitches.
To Next Page
Loading...