48
HYDROFIT™ Owner’s Information Manual
WARNING: The use and ownership of this work is defined in the legend upon the front page hereof.
Inspection Requirements
Controllers
Wires. Examine all wiring for breaks, loose lugs, or loose connections.
Resistance Tubes. Inspect for loose connections. Examine tubes for breaks
in the enamel. Replace broken resistance tubes with tubes of equal value.
Motors
Connections. Tighten all motor connections. Be sure to check all grounds and the
bonding of all conduits, and the controller frame, etc.
Car
Flooring. Inspect for worn or loose flooring.
Emergency Exits. Check operation of top exit and switch.
Lighting and Fans. Check for cleanliness, burnt out lamps, and for lubrication. Be
sure that globes are fastened.
Fixture Jewels and Lenses. Replace if any are cracked or broken. Glass used in
the car should be in accordance with codes.
Car Operating Devices
Pushbuttons. Buttons should not stick and should work properly. Replace worn
buttons and switches.
Indicators
Position Indicators. Position Indicators should be tested for proper operation and
checked for burnt out lamps.
Car Door
Fastenings. Examine fastenings and check the door opening range. Examine for
broken springs and loose connections.
Hangers. Check for worn tracks and rollers, making certain that the door cannot
come out of its guides or jam at any point.
Bottom Guides (Gibs). Examine for wear, looseness, or the possibility of the
guides coming out of the threshold.
To Next Page
Loading...