EasyManua.ls Logo

Otto Bock Genium - Warnings;error signals; Error while charging the product

Otto Bock Genium
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17.2.2 Warnings/error signals
Error during use
Beep signal Vibration signal Result Required action
1x long at intervals of
approx. 5seconds (if
mute mode (silent mode)
is activated, this signal is
not generated)
Overheated hydraulic unit Reduce activity.
3x long Charge level under 25% Charge battery soon.
Remaining operating time
approx. 24hours
5x long Charge level under 10% Charge battery soon
Remaining operating time
approx. 6hours
5x long 5x long repeated every
60seconds
Medium error (see
Page93)
e.g. a sensor is not oper
ational
Walking possible with restric
tions. Please note the change
in flexion resistance.
The product must be inspec
ted immediately by an author
ised Ottobock Service Center.
10x long 10x long Battery charge level 5%
After the beep and vibra
tion signals, the product
switches to empty battery
mode and then switches
off.
Charge the battery.
30x long 1 x long, 1 x short
repeated every 3seconds
Severe error/indication
of safety mode activa
tion (see Page93)
e.g. one or more sensors
are not operational.
Attempt to reset this error by
connecting/disconnecting the
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser
vice Center.
Continuous Total failure
Electronic control no
longer possible. Safety
mode active or undeter
mined valve state.
Undetermined product
behaviour.
Attempt to reset this error by
connecting/disconnecting the
battery charger.
If the error persists, use of the
product is prohibited. The
product must be inspected by
an authorised Ottobock Ser
vice Center.
Error while charging the product
LED on
power sup
ply
Status LED
on battery
charger
Error Resolution
Country-specific plug adapter not fully
engaged on power supply
Check whether the country-specific plug
adapter is fully engaged on the power
supply.
Non-functional socket Check socket with another electric appli
ance.
Defective power supply The battery charger and power supply
must be inspected by an authorised
Ottobock Service Centre.
100
Appendices
Genium 3B1-3/3B1-3=ST

Table of Contents

Other manuals for Otto Bock Genium

Related product manuals